B&K AVP3090 Owner's Manual - Advanced Operations

Page 30

Advanced operations

Star (

7

) operations (for zone 1 only)

The AVP has incorporated some new ways to change the mode of the source inputs.  In

the standard SETUP menu, the digital modes of VLD, CD ,V1 ,V2 ,TV-V3, and TUNER

are set globally and are not affected as presets are recalled.  Now with the 

U

(star)

operations described below, you can override the setup mode to another digital input

mode.  You can also save the new mode in an A/V preset for later recall.  What does all

this mean?  It means you can have presets for more than one digital mode of the same

input source.

For example, you can save one CD preset that uses the standard L,R analog inputs in

direct, and save another CD preset that uses the digital input with stereo.  Depending

on what you want to hear at the time, you can select the appropriate preset without

having to go through the SETUP menu and surround mode changes again.

It should be noted that only the DIGITAL ON mode, when set in the SETUP menu,

allows the AVP to automatically switch over to Dolby Digital Surround Processing when

a Dolby Digital digital input is detected.  This automatic feature also provides automatic

switching back to PCM, 30 seconds after an Dolby Digital signal is no longer present. 

Overriding the digital mode to DIGITAL OFF or DIGITAL DTS defeats the automatic

sensor.

Procedure

First select the preset you wish to change.  We will use preset 1 for this example but the

same holds true for all presets 0-9 and A0-A9.

Press 1, then ENTER to recall preset 1.

Set the input mode by selecting one of the following:

KEYSTROKE

MODE

U

(star) then 1 then 0

DIGITAL OFF

U

(star) then 1 then 1

DIGITAL ON

U

(star) then 1 then 2

DIGITAL AC-3

U

(star) then 1 then 3

DIGITAL DTS

Save the setup to preset 1 by pressing SAVE, then 1, then ENTER.