B&K CK1.1 Manual To Installation - Programming
Programming
Use the included CD-Rom to install B & K’s
Keypad editor on your windows PC. The CKEditor
runs on Windows 98, ME, 2000, XP and XP Pro.
It is best to do all programming in front of the
components with a CK1.1 connected to your lap-
top’s serial port. Each keypad must have its own
program downloaded to it.
To program, simply open the program, go to
the Program Menu and work your way
through the seven programming steps.
Once the program has been created in the
CK1.2 editor, select the CK1.1 tab on the
left side of the screen. Drag and Drop com-
mands and macros on the CK1.1 image.
Any macro, IR command or learned com-
mand can be programmed onto the CK1.1.
If you have questions, go to the Help Menu
and utilize the Keypad Programming
Manual.
Page 11
Using IR “Eyes” with the CK1.1
Sometimes additional IR recievers are required in some rooms in addition to
the CK1.1 Keypad. If additional IR receivers are used in a zone, they should
be treated like a slave keypad. Run a cable from the CK1.1 to the IR
receiver in the zone. The IR receiver should be pinned from the slave out-
put of the CK1.1 Keypad according the connection figure below:
IR R
ECEIVER
CK1.1 S
LAVE
O
UTPUT
1. IR DATA
PIN 2 - IR Data In
2. Ground
PIN 3 or 6 - Ground
3. 12+VDC
PIN 1 or 8 - +12 VDC