B&K CK1.1 Manual To Installation - And/or
Connecting To A CT Receiver
Keypads connect to the CT Receiver at the Zone Control terminals. There is
one terminal for each hardware zone labeled A-F on the CT600 and A-C on
the CT300.
You can terminate the Keypad cables to the Control terminals in one of two
ways:
1. If your cables are already terminated in RJ-45 plugs,
order the accessory “Terminal Block to RJ-45 Adapter”
(P/N 21419) separately from B & K .
Plug the RJ-45 plug into the adapter
and screw the adapter in place on the
CT Receiver. Be sure to match the
labels on the back panel to the labels under the pins
of the adapter.
AND/OR
2. You can strip the keypad cable and terminate five of the wires to the five
pin phoenix plug. If you are using CAT5 cable connected to the RJ-45 at the
Keypad, there are extra connections for Ground and 12V. These can be left
unterminated (though it does no harm to connect them). It is not important
that you use any particular color scheme, only that you connect one to one
as described here:
Page 6
RJ-45 MASTER[IN]
1. +12VDC IN
2. Data Out
3. Ground
4. N/C
5. RS-232 Receive
6. Ground
7. STATUS IN
8. +12VDC IN
CONTROL ZONE A-F
1. +12VDC IN
2. GROUND
3. RS-232 XMIT
4. DATA IN
5. CTRL OUT
CK1.1 Keypad
CT Receiver