Black owner’s manual model ___________ reverse osmosis drinking water systems authorized dealer ________________________ phone no. ______________________ owner’s manual model ___________ reverse osmosis drinking water systems authorized dealer ________________________ phone no. _____________________...
Contents congratulations! …………………………………….. 2 introduction ……………………………………………. 3 general hints …………………………………………… 3 how your reverse osmosis system works …. 4 directions for changing filters ………………. 5 installation instructions ………………………... 6 standard faucet installation ………………….. 7 air gap installation...
3 introduction your reverse osmosis (r.O) system provides clear, fresh water in your home. This compact unit is designed to force pressurized water through a semi-permeable membrane which rejects contaminants suspended in the water. This membrane permits passage of the improved water to a holding ta...
How your reverse osmosis system works your reverse osmosis system is completely self contained and uses stages for primary filtration and separations. First stage: prefilter the prefilter protects the reverse osmosis membrane from clogging by removing suspended and particulate matter larger than app...
Directions for changing filters how often you change your filters varies on the quality of water coming to the ro and the amount of water produced by the ro. The ro filters should be changed at least every year, but if water quality is low or high amounts of water are used, it is recommended that th...
Installation instructions see page 7 and 8 for illustration important: if water pressure exceeds 90 psi you must install a pressure regulator. Important: some ro’s use quick connect plastic fittings, to work properly the tubing must be smooth, cut straight and inserted completely into the fitting. I...
7.
8.
9 (must be cut to allow direct gravity feed to drain).
“i have too much total dissolved solids (tds) in the product water” 1. Membrane expanded. 2. Membrane attacked by chlorine. (does not apply to cta element) 3. Check valve failure on low control assembly. 4. Insufficient brine flow rate/screen on flow control assembly plugged. 5. Clogged prefilter/cr...
“my r.O. Is constantly running.” 1. Check tank pressure and check valve. “i’ve noticed poor taste/odors in the product water.” 1. Increase in product tds. 2. Postfilter expended. 3. Tank/system contaminated. 4. Tank diaphragm out of place. 5. Postfilter cartridge not completely flushed “the product ...
Service log date of installation _____________________ serial number _________________________ 12 date type of service comments.
13 4 & 5 stage ro.
Reverse osmosis systems model number:__________________________________________ general installation/operation/maintenance requirements do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. this reverse osmosis syst...
