B2 Audio M 12 Owner's Manual - page 5
B2
amplifier series recommends 12 AWG speaker connecting cables.
Keep speaker cables away from power cables and
B2
series amplifier's input cables.
Use grommets anywhere the cables have to pass through the holes in the metal frame or sheet
metal. Connect to the speakers according to terminals on each speaker.
Strip 3/8" of insulation from the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause a short circuit.
Crimp spade lugs over the cable ends or tin the ends with solder to provide a secure termination.
Connect the cable ends to
B2
series amplifiers as show on the speaker system diagram.
5
Run 12 AWG speaker connecting cables from your speakers to amplifier's mounting location.
4-
3
. SPEAKER CONNECTION
M12
2) Connect of Subwoofer 2 terminal to of Subwoofer
8 ~ 2 Ohms
to connect - from subwoofer 1 t0 + subwoofer2
!
Caution :
2) Connect of Subwoofer 2 terminal to of Subwoofer
Connect
of subwoofer
1)
2 OHM MONO BRIDGED MODE SPEAKER CONNECTION
2) Connect
of subwoofer 2 terminal to
of subwoofer 1 terminal to
3) Connect of subwoofer 1 terminal to of subwoofer 2 terminal
of subwoofer
SPEAKER CONNECTION DIAGRAM
Use 12 gauge Jumper wire
for bridged mode use only