B2 Audio Quattro Owner's Manual - page 3
Design features
Circuit Configuration:
4 ch class H
Frequency Response:
9 Hz ~ 42 KHz (+/- 1 dB)
Signal to Noise Ratio:
> 95 dB
Input Sensitivity:
0.2 V ~ 4 V
Crossovers Circuit:
12 dB / Octave
High Pass - HPF (CH1 / CH2):
50 Hz ~ 250 Hz
High Pass Active - TLA (CH1 / CH2): 1 KHz ~ 5 KHz
Tonal Level Adjustment - TLA:
-12 dB ~ 0 dB from HPF point
High Pass - HPF (CH3 / CH4):
50 Hz ~ 250 Hz
Low Pass - LPF (CH3 / CH4):
50 Hz ~ 250 Hz
Damping Factor:
> 800
Bass Boost @ 45 Hz:
0 dB ~ 15 dB
Remote
Control:
Optional
Fuse Rating:
3 x 25A
Thermal Protection :
80 C / 198 F
Dimensions:
178 x 51 x 340 mm / 7’’ x 2’’ x 13.38’’
All features are subject to change in the continuing effort to improve the products without notice.
Specifications
Continious output power (RMS) Measured @ 14.4 V THD < 0.5%
4 Ohm stereo:
100 W x 4
2 Ohm stereo:
150 W x 4
4 Ohm bridge:
300 W x 2
Description of Specifications
Stable impedance load of the Quattro is 2 Ohm stereo & 4 Ohm bridged.
Operation below minimum impedance will stress the amplifier & void the warranty.
Excessive heat will also appear at a faster rate and the and the amplifier will go into thermal protection.
Protection can also be caused by the following
* Speaker overload
* Short circuit
* Input Voltage - RCA & Power Supply
The PCB is a Class H design, optimizing efficiency, limiting dimensions & improving performance superior to
Class A/B with the same scale. (Don’t mistake it for a Class D which has less audible qualities compared to Class H).
The optional wired remote only affects CH 3 & 4.
Operational voltage: 10 V ~ 15.5 V.
Operational voltage will also be affected by the load of the amplifier.
3
Quattro