B2 Audio Quattro Owner's Manual - page 5
5
CAUTION
Panel layout
Quattro
CH2 CH1
CH4 CH3
SPEAKER
OUTPUT FUSES
Connection to the speakers leads.
The amplifier is fused with 3 x 25A.
Ensure polarity & corresponding channels are correct.
Remember fusing has to be done at
NB! Note the minimum bridged load.
the battery as well!
Connections below the stated will cause excessive
heat & the amplifier can go into thermal.
REM (REMOTE)
Continious thermal mode can cause damage & void
Connect to switched +12V from
the
warranty.
the
headunit.
+ 12V (POWER CONNECTION)
GND (GROUND CONNECTION)
Connects to the positive terminal of the battery (+12V).
For connection to the chassis’ ground.
For specified performance 4 GA cable is required.
Keep as short as possible (< 50 cm / 20”).
Fuses shall be placed within 20 cm / 8” of the battery.
Use minimum 4 GA cable for specified
performance.
Installation of the amplifier shall be done in the following steps:
1. Ensure the ground is appropriate, then connected it to the amplifier. 2. Connect the +12V wire, keep in mind this
wire has to be fused at the battery as well. 3. Connect the switched remote. 4. Reattach negative wire (ground) to
the battery. 5. Operation over 15,5 V will cause the amplifier to go into protect & can void the warranty!
GROUND
BATTERY
Head unit