B2 Audio Quota MKII Owner's Manual - page 6
3.3 Installation
+12V, GND, REM connection chart
FUSE
90A
Remote turn on
Head unit
Quota
Speaker wiring diagram
Wiring layout
We recommend using 12 AWG speaker cables to obtain increased performance.
Run 12 AWG speaker cables from your speakers to the amplifier’s mounting location
Keep the speaker cables seperate from the power cables and and the amplifier’s input cables.
Use grommets where the cables have to penetrate the vehichle’s chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause a short circuit.
Crimp spade plugs over the cable ends or tin the ends with solder to provide a solid terminal.
Connect the cable ends to the amplifer as shown in the speaker wiring diagram.
6
The minimum impedance is 1 .
CAUTION
POWER
B+
REM
GND
SPEAKER
SPK A
SPK B
BATTERY
GROUND
GROUND
POWER
B+
REM
GND
SPEAKER
SPK A
SPK B
Speaker Impedance 1~8
The Quota is not to be Linked / Strapped. Severe damages may occur if used in such a configuration.
Attempts of link / strap / bridge mode will void the warranty!
Caution