B2 Audio SLD5K Owner's Manual - page 7
7
wiring layout
sld600
BATTERY
Head unit
* Keep ground as short as possible, no longer
than 20” (50 cm).
GROUND*
We recommend to use minumum12 Ga speaker cables to acquire the intended performance.
Run the speaker cables from your speakers to the amplifier’s mounting location.
Ensure these are ran separately and away from high current cables and if possible the RCA cables as well.
In all cases where cables are penetrating the vechile’s chassis use grommets to protect the cable.
Connect the speaker wires according to the terminals on the speaker(s). Strip 3/8’’ / 1 cm of insulation of the end of
each cable and twist the cable strands together tightly. Make sure there are no stray strands that could touch other
cables or terminals as it can cause a short circut.
Crimp spade plugs over the end of the cable or tin the ends with solder to provide a solid terminal.
Connect the cable ends to the amplifier as shown in the diagram. Note, the amplifier’s speaker terminals are
internally bridged.
Speaker impedance 1 Ohm ~ 8 Ohm
Loads under what is specified will cause excessive heat & the amplifier
will reach thermal at a faster rate & will eventually go into protect.
Impedance load under 1 ohm is not warranted!
60A (External fuse)