B2audio Mono Owner's Manual - page 3
1. Design features
Circuit Configuration
Frequency Response
Signal to Noise Ratio
Input Sensitivity
Input Level Selector
Crossover
Low Pass Crossover Range
Subsonic Crossover Range
Bass Boost
Variable Bass Boost Range
Remote Control
Damping Factor
Power Terminal gauge
Fuse Rating
Mono
HI-EF Class D Mono
: 10Hz ~ 350Hz (+/- 1dB)
: 100dB
: 6V ~ 0.2V
: -
: 24dB / Oct
: 35Hz ~ 250Hz
: 10Hz ~ 50Hz
: 0 ~ 9dB
: 30Hz ~ 90Hz
:
: 300<
: 0 ga x 1
: 200A (External fusing required)
All features are subject to change in the continuing effort to improve the products without notice.
Power @ 4
Power @ 2
Power @ 1
(14.4V < 1% THD)
Mono
700 W x 1 1300 W x 1 2200 W x 1
Specifications (detailed)
2) The amplifier utilizes a 4 stage advanced protection circuit;
1) Thermal protection, 2) Voltage sensors, 3) DC offset, 4) Short circuitry via speaker outputs.
The PCB is a double sided SMD, with the lastest technology of high current mosfet switching
devices in both the in- and output stage.
4) A wired remote level control is included with the amplifier.
- This unit will enable remote gain adjustment & shall be used with caution.
High levels of boost can cause overexcursion & can lead to subsequent damage
(applies to the ampliers boost as well).
- For more advanced features like selectable bass frequency, boost level & gain,
the
Better Bass Remote
(optional) can be used.
5) The
Mono’s
24dB / Oct crossovers ensures optimum adjustment of both low pass & subsonic frequencies.
Specifications
Continious output power rating (RMS)
The
Mono
operates stable @ impedances of minimum 1 .
- Running the
Mono
at these impedances sets requirements to both ventilation & the battery system.
1)
3)
3
Phase
: 0 ~ 180