B2audio Mono Owner's Manual - page 8
Mono
8
3.31 Speaker wiring diagram
PROTECT
POWER
REMOTE
BOOST
FREQ.
LPF
PHASE
SUBSONIC
GAIN
BASS
SLAVE
MASTER
OUTPUT
SLAVE
INPUT
INPUT
CH2
CH1
0.2V
6V
10Hz
50Hz
0dB
9dB
30Hz
90Hz 35Hz
250Hz
0
180
MASTER
SPEAKER
Speaker Impedance 1~8 ohms
SINGLE AMPLIFIER SPEAKER CONNECTION
We recommend using 12 AWG speaker cables to obtain increased performance.
Run 12 AWG speaker cables from your speakers to the amplifier’s mounting location
Keep the speaker cables seperate from the power cables and and the amplifier’s input cables.
Use grommets where the cables have to penetrate the vehichle’s chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause a short circuit.
Crimp spade plugs over the cable ends or tin the ends with solder to provide a solid terminal.
Connect the cable ends to the amplifer as shown in the speaker wiring diagram.