B2B EL-26MC2RE User Manual - page 19
Key Lock
The function is to prevent from the kid’s playing or mis-press to change the setting. Press “Menu/Enter”
and select “Yes” to activate the key lock function, select “No” will close the key lock function.
If you want to release the Key Lock function you can press “Menu/Enter” and “Source/Exit” key
simultaneously.
Anti Burn-in
The function can prevent the LCD panel from burn-in when camera or DVR is always displaying the same
picture source at all times. Press “
▲/+” or “▼/-“ key to select “ Anti Burn-in” and press “Menu/Enter” to enter
the option and press
“
▲/+” or “▼/-“ key again to select (1). 15 Min (2). 30 Min. (3).60 Min (4).90 Min (6).Off.
To select 30 Min. the image will move left for one pixel for every 30 minutes, to select 60 Min, the image will
move left for one pixel for every 60 minutes, the other options are the same regulation.
3D NR
To use 3D NR to reduce the noise level and improve the video quality. There are four levels to select (1)
High (2) Medium (3) Low (4) Off. Press “Menu/Enter” and press
“
▲/+” or “▼/-“ key to select the level.
ID Controller
The ID function is only applicable for some specific models, if the model you brought has the ID function,
Please check the ID setup procedure on page 10.
Default
If you want to back to factory default, press Menu/Enter and then press “
▲/+” or “▼/-“ key to select “ Default”
“ . P
ress “Menu/Enter” key and press to “
▲/+” or “▼/-“ key activate “Yes”
Multi Screen (Video/HDMI Mode)
Press the “Menu/Enter” key on the buttons to call out the
OSD “Menu” . Press “
▲/+” or “▼/-“ to select “Multi
Screen” and press “Menu/Enter” key again to select the
“Multi Screen” option.
Multi-Screen
There are 4 multi screen modes to select (1) PIP (2) PBP (3) PBP 4:3 (3) Off . You may press “Menu/Enter”
and press “
▲/+” or “▼/-“ to select mode you want. “PIP” is Picture In Picture and “PBP” is Picture By Picture.
The PIP or PBP doesn’t allow the condition of Video on Video .
17