Instruction manual centrifugal juicer models cs / cse 40622.8 - março/2011 b i k aa a lb b i k aa a lb ® ®.
Summary 1. Introduction 1.1 main precautions 1.2 main components 1.3 technical characteristics 2. Installation and pre-operation 2.1 installation 2.2 pre-operation 3. Operation 3.1 starting 3.2 how to feed the centrifugal juicer 3.3 how to clog the sieve 3.4 production 3.5 cleaning 4. General warnin...
1 1. Introduction 1.1 main precautions the centrifugal juicers mod. Cs/cse are machines simple to operate and to clean they are useful to extract fruit and vegetable juices used by restaurants , and fast food professionals . To avoid accidents read the following instructions : 1.1.1before cleaning o...
1.2 main components all components are made with carefully selected materials for their function, in accordance with the siemsen standard testing procedures and experience . Among the principal components , are : 1-stump 2-feeding throat 3-bowl cover 4-handle 5-magnet support ( mod. Cse ) 6-guide 7-...
2 installation and pre-operation 2.1 installation to achieve a good performance the centrifugal juicer shall be installed on a steady and flat surface about 850 mm above floor . Check the voltage , be sure the network electric voltage is the same as the voltage indicated on the data plate label . Gr...
3. Operation 3.1 starting check if the sieve ( no.07 pic 2 ) is perfectly fit on the central shaft , the central shaft clogging pin shall not clog the shaft and the lid shall be secured by the two handles ( pic 11 ) . Be sure the assembly procedure stated at item 2.2 has been correctly performed. On...
3.3 how to clog the sieve the sieve may be clogged using the central shaft clogging pin ( no.19 pic 5 ) . The consequence of the day to day centrifugal juicer use , will be after some time , a natural wear of some components . Such wearing will produce a residual accumulation , and may cause the sie...
4.3 routine inspection watch out any abnormal noises coming from the motor or any moving parts . Check the safety devices to be normally operating . 4.4 operation 4.4.1 warnings long hair, that could touch the machine , could cause serious accidents . Tie them or cover them with a head scarf . Only ...
8 4.1.3 advices be sure this manual instruction has been fully understood . Each function or operation procedure has to be perfectly clear . Any manual command ( button , pulses , electric switch , lever, etc ) shall be given only after to be sure the correct command is given . If an electric supply...
