Baby Jogger City Versa Assembly Instructions Manual

Manual is about: Baby Strollers

Summary of City Versa

  • Page 1

    Read these instructions carefully before use and keep them for future reference. Your child’s safety may be affected if you do not follow these instructions. Www.Babyjogger.Com city versa ™ assembly instructions this product complies with bs en 1888:2003 inc. A1,2,3: 2005.

  • Page 2: Warning:

    2 2 • warning: this stroller is not suitable for running, jogging, skating or rollerblading. • warning: it may be dangerous to leave your child unattended. • warning: prevent serious injury to your child by always using the safety harness. • warning:child may slip into leg openings and strangle. Nev...

  • Page 3: Warning:

    1 • the passenger shall remain seated (no standing in the stroller). • watch out for cars – never assume that a driver can see you and your child. • this stroller seats one passenger. • this seat unit is not suitable for children under 6 months. • this stroller is suitable from 6 months to 5 years (...

  • Page 4: Table Of Contents

    2 table of contents unfolding & handle height adjustment front wheels & swivel rear wheels parking brake opening the seat attach canopy attach seat – forward & parent facing safety harness footwell angle & footwell length seat recline – forward & parent facing folding – forward facing folding – pare...

  • Page 5: Warning:

    1 1 2 turn stroller over to upright position. 1 lay stroller frame down so the handle is on the bottom. Begin to unfold stroller by pulling the auto-lock lever while pulling the lower frame up and away from the handle. The stroller will click into place. 3 snap red safety strap to the frame under th...

  • Page 6

    2 2 toinstallfrontwheels: 1 lay stroller back so the handle is resting on floor. 2 slide the wheel axle into the wheel mount until it clicks into place. Gently tug on the wheel to make sure it is locked into place. Repeat on other side. Toremovefrontwheels: 1 press gray tab on front wheel mount and ...

  • Page 7

    3 3 1 align rear wheel axle with rear wheel mount on stroller frame. Insert wheel axle into the wheel mount until it clicks into place. 2 gently tug on the wheel to make sure it is locked into place. Repeat on other side. Rear wheels to install rear wheels: 1 press the wheel release button while gen...

  • Page 8: Warning:

    4 4 brake •pull brake lever clockwise until it clicks into place. Gently push stroller to ensure the brakes are properly engaged. •push inward on the end of the brake handle to release the brake. The brake will flip down parallel to the stroller frame. To engage parking brake: to release parking bra...

  • Page 9

    5 5 to unfold the seat: 2 the seat will click and lock into its open position. 1 holding the footwell and the top of the seat, open the seat. Seat.

  • Page 10

    6 to attach the canopy: 2 align canopy bracket with open space on the seat frame. 3 firmly press the canopy bracket on the seat frame until it clicks into place. Repeat on other side. 1 place the rear of the canopy over the top of the seat frame. Secure canopy velcro ® to velcro ® on the seat fabric...

  • Page 11

    7 7 1 align seat adaptor brackets with mounting brackets on stroller frame. 2 the seat will click into place. To attach the seat: attaching the seat note: determinewhetheryouwant theseatforwardfacingorparent facing.Thestepsforplacingthe seatontheframearethesamefor eitherseatingdirection..

  • Page 12: Warning:

    8 8 1 pinch the top of the harness clip to unlock. 1 lift up on the bottom of the harness clip and remove harness strap from the side retainers. 2 slide the harness clip out and re-clip to the seat loop closest to the child’s shoulder height. 2 pull on strap end to tighten shoulder strap or pull on ...

  • Page 13: Warning:

    9 9 simply push top right buckle clip into the right side of the center buckle until it clicks into place. Repeat on other side. The buckles should always be clicked into place before using the stroller. Push one side of the center button and pull the corresponding side buckle clip away from the cen...

  • Page 14

    10 10 1 press large round buttons on upper portion of footwell. 1 there are two length positions on your footwell. Press in on small gray buttons on lower portion of footwell. 2 adjust footwell up or down to desired position and release buttons so it clicks into place. 2 slide in or out until it cli...

  • Page 15

    11 1 lift up on flat lever located under the top seat back. 2 while lifting up on the lever, pull down to lower seat and release the lever at the desired position. The seat will click into place. Seat recline to recline the seat: note: thestepsforrecliningtheseatarethesamenomatterwhichdirectionthese...

  • Page 16

    12 12 fold – forward facing 1 pinch seat fold buttons located beneath the recline lever on the top of the seat back. 3 unsnap red safety straps from both sides of the frame. 4 pull up on the handle marked "pull to fold." 5 the stroller will fold in half. 2 push seat forward until it is folded in hal...

  • Page 17

    13 13 fold – parent facing 1 pinch seat fold buttons located beneath the recline lever on the top of the seat back. 3 unsnap red safety straps from both sides of the frame. 4 pull up on the handle marked "pull to fold." 5 the stroller will fold in half. 2 push seat forward until it is folded in half...

  • Page 18

    14 14 storage strap 1 locate seat storage strap on the back of the versa seat. Unsnap the storage strap from its secured position on the seatback. 2 attach seat storage strap to stroller frame just below the fold mechanism. Aseatstoragestrapisprovidedtokeepyourcityversaseatinplacewhenfolded..

  • Page 19

    15 15 1 pull up on the auto-lock to release the frame while lifting up on the stroller handle until the frame clicks into place. 1 push gray tabs on both sides of the seat attachment brackets. 2 pull the top of the seat up to unfold until it clicks into place. 2 lift up and the seat will detach from...

  • Page 20

    16 removing the canopy & seat fabric 1 pull the canopy bracket out and away from the seat frame to detach. Repeat on other side. 2 detach canopy velcro ® from the seat velcro on both sides. To remove the canopy: 1 unsnap seat fabric from seat frame. 2 from the back of the seat, unfasten velcro ® and...

  • Page 21

    17 to remove the basket: 1 from the front of the stroller, unclip the plastic basket brackets from the stroller frame on both sides. 2 from the rear of the stroller, unsnap the basket snaps next to the center crossbar on both sides. 3 unsnap the basket snaps from below the center cross bar on both s...

  • Page 22

    18 18 to preserve the longevity of your stroller, it is important to perform simple, regular maintenance. From time to time, make sure that the joints and folding areas are still in good condition. If you hear any squeaking or feel tension, you can take your stroller to a local bike shop for added l...

  • Page 23: Warranty

    19 19 babyjogger'slimitedlifetimewarranty: •babyjoggerwarrantsthattheframeisfreeofmanufacturerdefectsforthelifetimeoftheproduct. Manufacturer’s defects include but are not limited to the breaking of welds and frame tube damage. •textileorsoftsidematerialsandallothercomponentsshallbewarrantedformanuf...

  • Page 24

    20 thebabyjoggercompany:8575magellanparkway,suite1000•richmond,va23227 t:800.241.1848•f:804.262.6277•www.Babyjogger.Com imported by kooltrade ltd. M34 3qa customerservice@kooltrade.Co.Uk • 0161 335 2508.