Baby Lock Amelia BL100A Instruction And Reference Manual - page 18
NEEDLE THREADER
Lower the lever as far as it will go
so the threader turns and the hook
pin will go through the needle eye.
Position thread below the needle eye
and under the hook pin.
Hold thread loosely and release the
lever. Hook will turn and pass thread
through needle eye while making a
loop.
Raise presser foot and pull thread out
about 10 inches from needle eye.
Note: The needle threader is used for
needle sizes 11, 14 and 16.
3.Lower the threader slowly and draw
thread through thread guide(A) and
pull toward the right.
2.Set needle in up position.
Hold the upper thread loosely and press
needle up/down button twice.
The handwheel will turn one complete
turn.
Pull both upper and bobbin threads about
10 inches toward the back and under the
presser foot.