Baby Lock Audrey BL67 Instruction And Reference Manual - Bobbin Winding

-11-

BOBBIN WINDING

WINDING THE BOBBIN

Pivot spool pin into highest position.

2.Pass thread from spool through thread guides as shown.

3.Pull end of thread through hole in bobbin as shown.

4.Move bobbin winder shaft to the left. Place bobbin onto shaft and rotate till it snaps

 into position with the end of thread coming from top of bobbin. Push bobbin winder

shaft to right until it clicks. Hold onto end of thread.

5.Start machine to wind the bobbin. Stop machine after a few turns to trim the

   thread tail with scissors. Bobbin will stop turning when completely filled.

   Cut the thread and push shaft to the left to remove bobbin.

4

5

3

2

1

2

1

REMOVING THE BOBBIN

1.Remove the bobbin cover by sliding the

   release lever to right and push down

   the left corner of bobbin cover at the 

   same time. 

2.Remove  the bobbin from the machine.

Place a spool of thread on the spool pin.

Secure it with the spool cap to ensure smooth flow of thread.

Use a spool cap closest in size to the spool of thread being used.

1.Raise presser foot lever.