Baby Lock Pearl BLQF Assembly Instructions Manual - Step 9
20
Step 9: Pole Bracket Assembly
Parts needed
1-Frame Assembly
1-Pole Bracket Assembly with Latches (right)
1-Pole Bracket Assembly without Latches (left)
4-M8x25 Socketed Button Head Cap Screw
QF09318-06
4-M8 Flat Washer QF09318-09
4-M8 Lock Nut QF09318-08
Tools Required
5mm Allen Wrench (provided)
17/13mm Wrench (provided)
9-1: Slide the left pole bracket assembly down
over the support rail on the left frame side
front. The pole bracket should straddle the
support rail. Attach the pole bracket assembly
using two M8x25mm QF09318-06.
Thread the screws through the center
hole of the pole bracket and the top hole
of the support rail from the outside to
Step 9
Pole Bracket Assembly
Fig. 9-1
the inside of the frame. (Other holes are
normally not used but were included to allow
future height adjustment if needed).
On the end of each screw, slide a flat washer
followed by a lock nut, as shown in Detail 9-1.
9-2: Visually level the pole bracket assembly
and fully tighten the two screws with the 13mm
wrench and 5mm Allen wrench.
9-3: Repeat Steps 9-1 and 9-2 to attach the
right pole bracket assembly, making sure the
ratchet stops are on the inside of the frame.
(Detail 9-2)
Detail 9-1
Use
Top Hole
Use
Center Hole
Detail 9-2