Baby TEL babyBOX Installation Manual - Cables And Babybox
Cables and babyBOX
babyBOX Installation Manual - Azacall
2
Cables and babyBOX
ETHERNET
CABLE (RJ-45)
TELEPHONE
CABLE (RJ-11)
POWER ADAPTER
CORD
Figure 1: Cables
Although similar in appearance, it is easy to tell the difference between the Ethernet cable and
the telephone cable. The Ethernet connector (RJ-45) is the larger of the two.
WAN
ENET
LINE
PHONE2 PHONE1
PWR
PWR
WAN
ENET
Phone1 Phone2
VoIP
Figure 2: babyBOX - Back and Front view
Back View (Jacks)
Front View (Lights On)
PHONE1 (Telephone): Your telephone set
connects to it.
PWR (Power): The power cord from the AC
adapter connects to it.
ENET (Ethernet): Ethernet cable from the PC
may connect to it, depending on your
configuration.
WAN (Wide Area Network): Ethernet cable
from the Modem or Router connects to it,
depending on your configuration.
PWR (Power): Indicates that the babyBOX is
powered on.
WAN (Wide Area Network): Indicates that a
modem or router is connected to this jack.
ENET (Ethernet): Indicates that a computer or
another device is connected to this jack.
VoIP (Voice over Internet Protocol): Indicates
that the babyTEL telephone service is ready.
Phone1 (Telephone): Indicates that the tele-
phone set connected to this jack is in use.
Note: Flashing lights can either mean that the babyBOX is rebooting, or babyTEL is upgrading
your system automatically. For more on the latter, please see Automatic Updates on page 16.