Baby TEL babyBOX Installation Manual - page 8
Cable Modem - Simple Setup
babyBOX Installation Manual - Azacall
4
Cable Modem - Simple Setup
You already have a Cable connection to the Internet. This means that you have everything you
need.
Getting ready:
First turn off the power to the cable modem and leave it unpowered for two minutes.
Disconnect the Ethernet cable that runs between the modem and the computer. [See Figure 1:
Cables for an illustration of the various cables.] Unpack the babyBOX and preserve the original
packaging in case you need to return the babyBOX to babyTEL for whatever reason. Now
proceed as shown below.
WAN
ENET
LINE PH 2 PH 1
PWR
WALL
CABLE
OUTLET
CABLE
MODEM
4
PWR (POWER)
WAN
1
ENET
2
PHONE1
3
babyBOX
Figure 3: Cable Modem - Simple Setup
(1)
Connect an Ethernet cable from the Ethernet jack of the cable modem to the WAN jack of
the babyBOX. [See Figure 1: Cables for an illustration of the various cables.]
(2)
Connect a second Ethernet cable from the ENET jack of the babyBOX to the Ethernet jack
(also called Network Jack) of the computer.
(3)
Connect your telephone set to the PHONE1 jack of the babyBOX.
(4)
Power up the cable modem and wait a few moments for it to boot up. Plug the AC adapter
that came with the babyBOX into a wall socket, or preferably, into a surge-protected
power bar. With the cable modem now powered and ready, connect the power cord from
the babyBOX power adapter to the PWR socket of the babyBOX.
Wait a few minutes for the babyBOX to boot up. When the lights on the babyBOX have stopped
flickering and the VoIP light is on, you are ready to use the babyTEL service or surf the Internet.
When you pick up the telephone receiver you should hear a dial tone. Dial a friend to see that it
works.