Baby Trend Sit N'Stand Double Instruction Manual - Warning:
Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
PLATFORM - Safety Belt
• Secure the stand feature safety belt behind
child and engate buckle (Fig. 21). This is the
same safety belt you use to secure the rear
infant car seat.
TO RECLINE SEATS
FRONT SEAT
The front seat has a two position recline. To
recline the seat, rotate the recline bar and press
backward on the seat back. (Fig. 22) To place the
seat in the upright position, press upward on the
seat back while rotating the recline bar.
WARNING:
The upright
position should be used only for a
child that is at least 6 months old.
REAR SEAT
To recline the rear seat locate the plastic adjuster
and squeeze the ends. Loosen or tighten the strap
to your desired recline position. (Fig. 23)
TO ATTACH INFANT CAR SEAT
To attach Baby Trend infant car seats, rotate child
trays to the vertical postion first. See rotate child
tray for more details.
SAFETY
9
10
WARNING:
When loading,
car seat in REAR position first, then
2nd car seat in FRONT position.
When unloading, remove FRONT
car seat first then REAR car seat.
WARNING:
Avoid serious
injury from falling, ALWAYS use
the safety belt to secure both of
FRONT and REAR car seats.
Attach the rear infant car seat:
Recline the back seat to the lowest position. Turn
the red tabs inward on the stroller frame. (Fig. 24)
Position the infant car seat, facing toward the rear
of the stroller, so that the seat shell goes into the
rear child tray and latches into place. (Fig. 25)
Attach the front infant car seat:
Recline the front seat back. Postion the infant car
seat, facing toward the rear of the stroller, so the
seat shell goes into the front child tray and latches
into place. (Fig. 25)
Check that the infant car seat is firmly locked onto
the child tray then
STRAP THE SAFETY BELT
OVER THE CAR SEAT
through the seat belt
slots on the infant car seat, connect the buckles
together. (Fig. 26) Tighten the strap so the infant
car seat fits snug and can't move.
IT IS VERY IMPORTANT THAT THE INFANT
CAR SEAT STRAP IS ALWAYS TIGHTLY
FASTENED AROUND THE INFANT CAR
SEAT.
To remove infant car seat:
Squeeze the release handle located at the foot-end
of the infant car seat and carefully lift upward.
(Fig. 27)
SAFETY
Fig. 21
Fig. 22
Fig. 23
Fig. 25
Fig. 24
Fig. 26
Fig. 27