BaByliss 2800DU Manual - Instructions For Use
INSTRUCTIONS FOR USE
General
• Ensure the hair is dry and combed through.
• Fit the required attachment as described below, ensuring that the
attachment is locked into position.
• To remove the attachments ensure the appliance is cool and
unplugged. On the power handle there are two slide switches on the
top and lower housing. Slide back the switches individually and pull
to release the separate attachments.
• Follow the instructions for each attachment as stated below.
• Plug the appliance into a suitable mains socket and switch on, the
‘on’ indicator light will illuminate.
• Always place on a firm surface using the safety stand on the base of
the appliance.
• Do not place the appliance on any heat sensitive surface.
• Allow the appliance to heat up.
IMPORTANT! The element of the appliance will become very hot when
plugged in and switched on. Before fixing or removing any attachments,
ensure the appliance is cool, switched off and is unplugged.
13MM/16MM/19MM TONG ATTACHMENTS
To create, tight or loose curls:
- Use the 13mm tong to create tighter curls
- Use the 16mm tong to create defined curls
- Use the 19mm tong to create loose curls
Fitting The Tong Attachments
• To achieve your desired style, insert the correct size tong in the
bottom slot of the power handle. On the bottom of the attachment
there is a small ridge, ensure this is facing downwards and then push
the attachment into the handle until it clicks into place.
• Hold the handle in the closed position and insert the spring lever in
the top slot of the appliance. On the top of the spring lever attachment
there is a small ridge, ensure this is facing upwards and then begin