1. DL manuals
  2. Bacchus
  3. Air Conditioner
  4. BCS1000
  5. Installation Manual

Bacchus BCS1000 Installation Manual

Summary of BCS1000

  • Page 1

    1 installation manual bcs 1000/1500 supplies needed for installation 1. Double insulated refrigerant line set. 2. 1/4” copper water supply 3. 1/4” condensate vinyl drain tube/tube clamps 4. Provide 120v 15a circuit for indoor evaporator, and 120v/230v 30a, single or three phase (dependent upon your ...

  • Page 2

    2 3. Run the recommended double insulated line set from the condensing unit to the evaporator opening (50 foot max.). 4. Power from disconnect (recommended) 12-2/with ground to the condensing unit. 5. Check low pressure control for the correct 25 psi setting, with a 15 psi differential. Diagram 1 ev...

  • Page 3

    3 evaporator set up, continued 6. Wrap the txv and refrigeration solenoid with esp heat block (#hb34) or comparable product. Braze the refrigerant solenoid to the liquid line. Remove the txv bulk and braze in the suction line to the line exiting the condenser. Re-attach the bulb when cool. 7. Locate...

  • Page 4

    4 controller display set up 1. Install double gang box and cut out the blank plate to accept the bacchus temp/humidity keyboard (vh620). The keyboard can be mounted inside or outside of the room. Run 18-2 stat wire from the monitor back to the evaporator above the ceiling opening, and attach to the ...

  • Page 5

    5 11. Alarm signaling message cause outputs “p1” thermostat probe failure compressor and heating outputs off (on dehumidification system only) “p3” humidity probe failure humidity regulation off “ha” high temp alarm outputs unchanged “la” low temperature alarm outputs unchanged “hha” high humidity a...

  • Page 6

    6 charging the system 1. Evacuate and pressure test the system. This can be accomplished by charging with nitrogen to 75 lbs and checking your gauges for any sign of a leak. Evacuate the system to 500 microns. 2. Charge the system with r134a until the sight glass goes clear. It is very important not...

  • Page 7

    7 troubleshooting alarm conditions on the electronic controller, call bcs tech services at 937-665-0424 unit will not reach temperature call your installation contractor to determine proper refrigerant charge. Dirty condenser? Unit has shut off call bsc tech services or field service; could be bad c...

  • Page 8

    8 phone: 937-665-0424 fax: 937-890-6664.