BackStopper CA-5030 Installation Instructions Manual - page 3
Manual is about: Rear Parking Assist System with CMOS Color Camera and 3.5" LCD Monitor
of
16
CAR BUMPERS
TRUCK BUMPERS
(2) Sensor Install
(4) Sensor Install
2 - 2.5 feet
1 - 1.5 feet
1 - 1.5 feet
1 - 1.5 feet
Use the provided hole saw bit to drill sensor holes
Bumper
Sensor
Sensor
Shim
SENSOR DIRECTION
Install the sensors onto a flat bumper surface. Make sure that the angle is not too extreme up or down. If the angle is too
extreme, the sensors may not work correctly. If you need to angle the senosors back up or down or you have a curved
bumper surface, please use the provided plastic shims to adjust the angle
Flat
Bumper
Curved
Bumper
Curved
Bumper
Route the sensor cables through the hole and snap
the sensor into place on the bumper
GOOD
NOT
GOOD
NOT
GOOD
GOOD
1.5 - 2.5 feet
(Height)
(Width)
(Width)
1.5 - 2.5 feet
(Height)
(Width)
(Width)