Flow monitor b2800 panel mount standard dsy-pm-00278-en-04 (november 2017) user manual.
Contents scope of this manual 3 unpacking and inspection 3 safety 3 terminology and symbols 3 considerations 3 introduction 4 installation 4 operating the monitor 5 buttons 5 modes 5 programming 6 programming mode 6 run mode 7 additional scaling parameters 8 flow 4 ma setting 8 flow 20 ma setting 8 ...
Scope of this manual this manual is intended to help you get the b2800 flow monitor up and running quickly mpootant i read this manual carefully before attempting any installation or operation. Keep the manual accessible for future reference. Unpacking and inspection upon opening the shipping contai...
Intooduction the b2800 flow monitor is a state-of-the-art digital signal processing flow monitor, designed to provide exceptional flexibility at an affordable price though it is designed for use with blancett flow meters, this display can be used with almost any flow meter producing a low amplitude ...
Opeoating the monitoo rate / total display and programming choices units display and programming choices mode indicator programming keys figure 3: b2800 panel mount flow monitor buttons menu switches to program mode up scrolls forward through the parameter options and increments numeric variables oi...
Poogoamming each turbine flow meter is shipped with either a k-factor value or frequency data if frequency data is provided, the data must be converted to a k-factor before programming the monitor k-factor information, when supplied, can usually be found on the neck of the flow meter or stamped on t...
Select the units of measure the monitor is programmed with five common rate/total unit options the monitor shows the rate/total unit that the display is currently set for if the current selection is correct, press enteo once to advance to the display function parameter to change the unit, press up o...
Additional scaling paoameteos otee: n the programming instructions below are only available for loop powered units battery powered units do not include these programming parameters flow 4 ma setting zero is the default flow rate at the 4 ma setting if the current selection is correct, press enteo to...
Batteoy oeplacement battery powered monitors use a single 1 5v, d size, alkaline battery when replacement is needed, use a clean, fresh battery to ensure continued trouble-free operation it is recommended that the total be saved to memory before the battery is removed 1 carefully unscrew the enclosu...
Specifications power supply options battery powered one d size, 1 5v alkaline battery loop powered optional 4…20 ma loop power alphanumeric oate and total display eight digit, 0 50 inch high numeric display eight character, 0 25 inch high alphanumeric display fixed or toggle modes of operation for f...
Dimensions a b c d e a b c d e 4 25 in (107 9 mm) 4 25 in (107 9 mm) 0 75 in (19 0 mm) 2 50 in (63 5 mm) 4 54 in (115 3 mm) tooubleshooting guide issue oemedy no lcd display • check battery voltage should be 1 5v dc replace if low or bad no rate or total displayed • check connection from meter picku...
Default k-factoo values meter size default k-factor lower limit upper limit 3⁄8 in (9 53 mm) 20,000 16,000 24,000 1/2 in (12 7 mm) 13,000 10,400 15,600 3/4 in (19 05 mm) 2750 2200 3300 7⁄8 in (22 23 mm) 2686 2148 3223 1 in (25 4 mm) 870 0 696 0 1044 1-1/2 in (38 1 mm) 330 0 264 0 396 0 2 in (50 8 mm...
