Baird TI4203BC User Manual - page 8
8
GETTING STARTED - INITIAL SET UP
1) Using the RF cable supplied, connect the TV to
the TV Aerial wall socket (Fig A)
2) Connect the power cable to the Electrical outlet
(Fig B)
5) You will now be welcomed with the initial set-
up screen. If it does not appear, on the remote
control, please press [MENU] then 8-8-8-8 and the
menu will appear. Press OK on the remote control
and tuning will start.
If you are missing channels, the reason for this is likely to be signal strength, you should
consider connecting signal booster and re-tuning the TV.
4) Insert the batteries supplied into the Remote
control and press the Standby button to power on
the TV. Take care to observe correct polarity.
3) Switch on the television using the power on/
off switch.
Tip: If the TV fi nds some, but not all, of the Digital channels, the TV is functioning correctly but the signal being
received is not strong enough. (The signal strength needs to be above 85% - you can see the signal strength
the TV is receiving when you change channels/ programmes) you will need to increase the signal reception
in order to receive all of the channels available. The most economical way to do this is by purchasing and
connecting a ‘signal booster’ in between the TV and the TV aerial socket. If this does not solve the problem,
you will need to upgrade the TV aerial to a digital hi-gain compatible aerial
Fig A
Fig B
Getting Started - Initial Set Up
ON
OFF
Signal Booster
Connect between TV
and TV aerial socket