Baird TI4603BC User Manual - page 8

8

GETTING STARTED - INITIAL SET UP

Getting Started - Initial Set Up

1) Connect the TV to the TV Aerial wall socket

(Fig A)

2) Connect the power cable to the wall socket, 

ensuring the wall socket is OFF.

3) Insert the batteries into the Remote control. Take 

care to observe correct polarity.

4)  Switch on the wall socket and then the 

television using the red (power) button on the 

remote control: or on the bottom of your TV.

Fig A

Fig B

5. You will now be welcomed with the initial set-up 

screen. Press OK twice to confi rm OSD LANGUAGE 

and COUNTRY. Then press OK again and the auto 

tuning will start.

6) After tuning the following screen will appear.

Press OK to confi rm Country Code, again to 

confi rm Primary region and twice more to confi rm 

Secondary and Territory Regions. Your fi rst

Programme should now appear.

Tip: If the TV fi nds some, but not all, of the Digital channels, the TV is functioning correctly but the signal being 

received is not strong enough. (The signal strength needs to be above 85% - you can see the signal strength 

the TV is receiving when you change channels/ programmes) you will need to increase the signal reception 

in order to receive all of the channels available. The most economical way to do this is by purchasing and 

connecting a ‘signal booster’ in between the TV and the TV aerial socket. If this does not solve the problem, 

you will need to upgrade the TV aerial to a digital hi-gain compatible aerial

Signal Booster

Connect between TV

and TV aerial socket