Baja motorsports BV250 Setup Instructions

Other manuals for BV250: Owner's Manual

Summary of BV250

  • Page 1

    Bv250 motorcycle set up instructions 1. Remove motorcycle from cardboard carton and metal frame. Reva 081307.

  • Page 2: Parts

    Parts handlebar attachment windshield mirror 2. Rotate handlebars out. Secure with handlebar tightening cinch bolts provided. Torque bolts to 17ft.Lbs. Rotate handlebars out handlebar tightening cinch bolt. Torque bolt to 17 ft.Lbs. Nut phillip head bolt and nut.

  • Page 3: Mirror

    Mirror 3. Attach left and right mirrors using hardware prodvided. Windshield 4. Attach windshield to front of motorcycle using phillips head bolts and nuts provided (qty. 6 nuts and bolts) . Phillips screw driver phillip head bolt and nut nut.

  • Page 4: Battery

    Battery warning the following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eye wear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes. Keep all children away from the area while this procedure is being...

  • Page 5: Battery

    Battery note: the following page is for vehicles with battery’s containing separate electrolyte pack. Most battery’s will come with the electrolyte already sealed into the battery. Preparing the battery: · place battery on level surface. Remove vent cap from battery vent located on top side portion ...

  • Page 6: Battery

    Battery warning never remove the strip of caps nor add any water or electrolyte. Black (-) red (+) how to initially charge the battery: 1. Connect the red positive (+) cable to the red positive (+) pole of the battery. (see figure 24) 2. Connect the black negative (-) cable to the black negative (-)...

  • Page 7: Battery

    Battery replacement: · remove old battery. Mark which cable is connected to the positive terminal (+) and which cable is connected to the negative (-) terminal. · clean cable connectors with wire brush or sandpaper to remove oxidation. · after charging, install new battery. Put dielectric grease on ...

  • Page 8: Gas and Oil

    Gas and oil 6. Fill gas tank as specified in owners manual. 7. Refer to owners manual for proper starting instructions. !!Warning!! This engine may be shipped with oil. This oil should be drained and replaced with new engine oil as described in the owners manual. Never attempt to start the engine wi...