1. Remove cardboard carton. Removal from carton sc150 scooter set up instructions 2. Remove metal frame, plastic covering, hardware and all parts provided..
2 parts front wheel tools mirrors battery rear luggage carrier headlight panel hardware rear shocks 3. Lift rear end to attach left and right rear shocks using bolts provided. Torque to 17 ft.Lbs. Fender a.
3 rear luggage carrier 5. Remove hardware provided for assembly. Attach handlebar stem to steering stem. Torque to 33 ft.Lbs. 6. Secure all wires with zip tie. Handlebar bolt nut 4. Attach rear luggage carrier using hardware provided. 6mm bolts torque to 7 ft.Lbs. 8mm bolts torque to 17 ft.Lbs..
4 front fender 7. Attach fender a to fender b using 1 phillip head screw. 8. Attach each side of front fender to fork with 4 phillip head screws, 2 on each side. Phillip head screw fender a fender a fender b.
5 9. Align speed sensor between front wheel and front fork. 11. Remove brake caliper shipping spacer and discard. Attach brake caliper to front forks using bolts provided. Torque bolts to 7 ft.Lbs. Shipping spacer axle bolt speed sensor alignment tab on front fork 10. Place front wheel spacer betwee...
6 12. Connect headlight wire. Align tabs on headlight panel with grooves on console. Tab groove 13. Secure headlight panel using phillip head screws. Headlight panel.
7 14. Attach left and right mirrors to handlebar assembly using allen head screw, lock washer and spacer. Mirrors allen head screw lock washer spacer.
8 battery located in floorboard under mat. Battery installation warning the following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eyewear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes. Keep all ch...
9 note: the following page is for vehicles with battery’s containing separate electrolyte pack. Most battery’s will come with the electrolyte already sealed into the battery. Preparing the battery: · place battery on level surface. Remove sealing tape from top. (see figure 20) · take the electrolyte...
10 warning never remove the strip of caps nor add any water or electrolyte. How to initially charge the battery: 1. Connect the red positive (+) cable to the red positive (+) pole of the battery. (see figure 23) 2. Connect the black negative (-) cable to the black negative (-) pole of the battery. (...
11 13. Fill engine with correct amount of oil. Refer to owners manual for oil types and quantity. 14. Fill gas tank as specified in owners manual. Oil plug. Gas and oil !!Warning!! This engine may be shipped with packing oil. This oil should be drained and replaced with new oil as described in the o...
