Bake Max BMDSD01 User Manual - page 10
3. How to operate
Once the bowl has been cleaned, fill the tank with the desired product (4.51, 1.2gallons).
Do not overfill the tank. Note that when filling, shush occupies more volume than the liquid
(approximately 1 gallon of slush). Be sure to consider product ratio (not exceeding
1
gallons total
mix for slush) before mixing or pouring product into tank. In order to keep your machine in good
working condition, keep your machine full.
If using natural products as a base (coffee, lemon juice, orange juice, etc.), it is required that 5 to
7 oz. of sugar per gallon be added. Follow the dilution instructions on the bottle. In general the
mix ratio of the product shouldn't be less than 12.
To Start the agitator, press main power and agitator switches to on position,
Figure 8. Note: Depending on the version of your machine, the control panel may
look differently then figure 8, please also refer to switch symbols. Note that your
machine is equipped with a time delay relay that provides for a three minute delay
from the time of the initial start. This is to prevent the compressor from short
cycling.
1.
For liquid, press the cooler switch to bottom position. For slush, press the cooler
switch to up position.
Note:The switch is a three position switch and order to have the machine off, the switch needs
to be in the middle position.
2.
If machine is being used as a liquid cooler, the switch at liquid position, up, is
provided with an inside thermostat for controlling the liquid temperature.
To illuminate the transparency on top of the unit and the product in the bowl press the display light
switch to up position.
Figure 8