Bake Max BMDSD01 User Manual - page 8
Cleaning and Maintenance
To maintain high degree of food quality this machine
should be cleaned and sanitized
1. Turn the Freeze/refrigerate switch to the off position.
2. Draw off the remaining product.
3. Fill the machine with clean warm water
4. After two or three minutes draw off the water and discard
5. Turn the agitator switch to the off position
6. Turn off the main power switch and remove the plug from the power source.
7. Remove the bowl covers and wipe clean with warm detergent water. DO NOT IMMERSE.
8. Remove the bowl by gently lifting the front and pulling. Once the bowl is free slide it off the agitator.
9. Slide the agitator off the cooling cylinder
10. Remove the large ~0" ring at the back of the bowl and soft seal on the drive shaft
11. With mild detergent and warm water wipe all the machine surfaces.
12. Remove the tap assembly on the bowl by pulling out the locking pin
13. Remove the "O" ring and seal from the draw valve.
14. Wash all parts in warm detergent water Rinse and allow to air dry.
Reassembly
1. Lubricate the "O" ring and seal on the draw valve.
2. Insert the draw valve assembly into the bowl and hold in place with the tap handle and
secure the tap handle with the locking pin
3. Lubricate the inside of the soft seal and slide it into position on the drive shaft.
4. Position the large "O" ring on the back of the cooling cylinder.
5. Lightly lubricate the silver bush located in the front of the bowl.
6. Lightly lubricate the outside of the silicone seal on the drive shaft.
7. Slide the agitator onto the cooling cylinder
8. Slide the bowl over the agitator and align it with the large "0" ring at the back of the cooling cylinder.
9 Align the agitator with the silver bushing in the front of the bowl by lifting the agitator while sliding the
bowl into position.
10. Ensure the bowl is set in position with the slot in the front sides of the bowl's base locked over the
machine edge.
11. Fill the machine with sanitizing solution and am without refrigeration for five minutes
12. Drain and rinse the machine.
13. The machine is now ready for use