Balanced Audio Technology VK-200 Owner's Manual - page 6
Operating the VK-200
Turning the VK-200 On:
The power switch is located on the VK-200 front panel. If VK-200 was turned OFF even for
a short period of time, you should wait at least 30 seconds before turning it back ON. This
precaution will minimize the stress on internal components.
When you turn the unit ON, the VK-200 will automatically go through a gentle power-on
sequence. At the end of a 10 second delay the unit will unmute and become operational.
Fuse Protection:
The circuitry of the VK-200 is protected by the following fuses:
1. The main line fuse is located on the back panel. This fuse should be checked if the
front panel blue LED’s fails to light.
2. Two internal fuses are mounted on each of the two amplifier circuit boards. These fuses
have two green LED’s associated with them. Both LED’s should be lit when unit is ON and
operating properly. Failure of either of these LED’s to light indicates that the corresponding
fuse is open.
CAUTION:
Make sure that the VK-200 is turned OFF and disconnected from the power line
before proceeding with checking or replacing fuses.
A blown fuse in the VK-200 is an indication of a serious problem. If a replacement fuse fails
as well, no further attempts at servicing the unit should be undertaken. Please contact the
factory for professional service.