Balanced Audio Technology VK-33 Owner's Manual - page 7
7
VK-33 FRONT PANEL CONTROLS
STANDBY Button and LED
The Standby button is used to turn the unit ON and OFF and to switch the
preamplifier into its Standby mode. The LED indicates the status of the unit’s
power circuitry and has four state:
LED OFF
Display OFF
Unit is in OFF state
Display ON
Unit is in ON state
LED Flashing
Unit is going through its Power-ON routine
LED ON
Unit is in its STANDBY mode
When the unit is plugged into a power line, it will stay in the OFF state until the
Standby button is pushed. The LED will then start blinking and the unit will go
through a 50second warm-up sequence. At the end of that sequence it will turn
ON.
Pressing the button again will switch the unit into its Standby mode.
The VK-33 can be turned OFF by
pressing and holding
the Standby button.
VK-33 Power-On sequence:
When you turn the VK-33 On, it will automatically go through a gentle power-on
sequence. This sequence takes 50 seconds, during which time the display and
the Standby LED will be flashing, indicating the status of the unit.
1. The number on the display during this time indicates the volume setting.
This will usually start at 000. This setting can be changed during this time
by using the volume knob or Volume Up/Down buttons on your VK-R3
remote control transmitter. In addition, such functions as Phase, Mono,
input selection and Mute can be changed during this time either from front
panel or through the remote control.
2. Normally the VK-33 will be
not muted
(Mute LED on the display is OFF) and
will begin playing at the end of the 50 second delay. If so desired, the unit
can be put in the MUTE mode during this delay interval either by depressing
the front panel MUTE switch or by using the MUTE button on the VK-R3
remote control transmitter.
Turning the VK-33 Off:
The unit can be turned OFF by
pressing and holding
the Standby button. It will
automatically mute.