Balanced Audio Technology VK-53SE Owner's Manual - page 14
14
Alternatively, the volume offset number can be entered directly, based on your
judgement of volume difference between the two sources. To do that, select the
input, enter the VOLUME programming mode by pressing the Function button
twice, and use the volume knob to set the volume offset number that you deem
desirable. Then exit the programming mode by
pressing and holding the
Function Button
.
NOTE: A negative number for the selected input indicates that its
gain will be set lower than the gain of the reference input.
PHASE programming.
Select the desired input.
Press the Function button three times. The display will read: PHASE NINV.
Use the volume knob to set the condition to NINV, INV or LAST.
Exit the programming mode by
pressing and holding the Function
button
.
NOTE: In the LAST mode, the state of the PHASE switch will be the
same as used the last time for that particular input.
MONO/STEREO programming.
Select the desired input.
Press the Function button four times. The display will read: STEREO
Use the volume knob to set the condition to STEREO, MONO or LAST.
Exit the programming mode by
pressing and holding the Function
button
.
NOTE: In the LAST mode, the state of the Phase switch will be the
same as used the last time for that particular input.
MAXIMUM gain programming
It may be desirable to limit the allowable volume setting on a particular input. To
do this:
Select the desired input