Balanced Audio Technology VK-53SE Owner's Manual - page 18
18
accelerate, allowing for more flexible control when large changes in volume are
required.
Mute
Pressing this button will cause the MUTE function in the VK-53SE to toggle
between ON and OFF states. The Mute LED on the VK-53SE front panel will
reflect the status of the Mute circuit.
Fade
Pressing the FADE button on the VK-R3 remote control will cause the volume to
smoothly decay over the period of several seconds. This allows for a gradual
reduction in volume, as opposed to the instantaneous MUTE function. This can be
particularly useful during the presentation or demonstration of your equipment.
When the FADE button is pressed, the volume will go down all the way to zero
(000 on display, unit in Mute).
Pressing the Fade button again will cause the volume to ramp back up to its initial
value.
INPUT SELECT:
Pressing any input selection button on the VK-R3 remote control will switch the
VK-53SE to that input. All of the set parameters associated with that input
would be loaded at this point.
DISPLAY/POWER switch.
The Display/Power button on the VK-R3 remote control provides two functions:
turning the VK-53SE display ON/OFF and switching the power to the
preamplifier.
To control the display:
Pressing the display button will reduce the brightness of display and LED
indicators in steps from full ON to OFF, and then one press back to full ON.
Turning the VK-53SE OFF
With the display in ON state, press and hold the Display button on the VK-
R3 remote control. This function is disabled when the unit’s display is
turned OFF.