Balanced Body Allegro Reformer Manual - page 15
13
How to Install the Allegro
®
Legs Kit
PARTS INCLUDED:
Item No. Part Number Description
Qty
1
618-030
Allegro Leg, A
2
2
618-031
Allegro Leg, B
2
3
618-021
Leg Nut Plate
2
4
ALL0091
Rubber Pad, Leg, Allegro
4
5
614-020
Wheel Bracket, Allegro Ext
Leg
2
6
GEN8320
Allen Key, 3/16” Ball Point
1
7
GEN9222
Screw, Button Head, 5/16-18
x 3/4”
12
8
GEN9472
Screw, 1/4-20 x 3/4”
4
9
GEN9021
Nut, Nylock, 1/4-20
4
10
GEN9282
Allen Key 5/32” Short Arm
1
TOOLS NEEDED (NOT INCLUDED):
»
Two 1/2” or adjustable wrenches
»
One 7/16” wrench
1. If you have a Tower Of Power installed, remove the ropes,
loosen the 4 tower knobs, and remove the tower.
2. Using the included shorter allen wrench, remove the 4 screws
holding the head end cover plates and riser pins in place. Set
them aside to be re-installed later. See Figure A.
3. Attach all springs to keep the carriage stationary. Remove
ropes, shoulder rests, and risers. Place the footbar (if installed)
in its lowest position and check that all pins are locked so that
the footbar is secure. Then, with the help of a friend, lift the
Allegro from both ends and carefully turn it upside down and
set it on the floor. You may want to place a pad or other floor
protection beneath the Reformer.
1
2
4
3
6
5
10
8
7
9
Figure A