Balanced Body Allegro Reformer Manual - page 20
18
NOTE: If you have an original version of the Allegro with the
angled corner joints (Serial Number less than 36396), follow
these instructions.
a. Using the provided 5/32” Allen wrench, loosen and remove
the six screws (one on each side of the Reformer and 4 on
the head end) that hold the head end of the frame on. Take
note of how the plastic shims between the frame members
are oriented and how they fit.
b. Install the Tower brackets as described in step number 3
below. Do not tighten the bracket screws.
c. Re-install the head end of your Reformer frame with the
plastic shims and screws removed in step a. The two shorter
bolts go in the sides of the frame and the 4 longer ones go
in from the head end. Tighten the screws until they are snug,
do not over tighten them.
d. Position the Tower brackets so they line up with the edge of
the frame screws on the side of the frame. Then tighten the
Tower bracket screws as described in step 4.
e. Follow the instructions from step 6 until the end.
1. Using the provided 5/32” allen wrench, remove the plastic rail
caps and locking pins at the head end of the Allegro frame.
They will need to go back on the same side, so keep track of
which one goes where and keep the screws with them. See
Figure A.
2. Screw the spacer into the predrilled hole in the side of the
frame. Repeat on the other side. See Figure B.
3. Installing the Tower Mount Brackets:
a. With the provided 5/32” allen wrench, loosen the 6 screws
on each bracket 1-2 turns. Do not remove them, you just
want some free play between the plates. See Figure C.
b. Make sure the brackets are oriented as in Figure C (use
the large grey knobs and screws as reference) and slide
them into the C-channel of the frame until they touch the
spacer you installed in step 2.
4. Using the provided 5/32” allen wrench, tighten the 6 screws
on both Tower brackets. Make sure the bracket is slid all the
way up against the spacer you installed in step 2. See Figure
D.
Figure A
Figure B
GEN9346
ALL0004
Figure C
Loosen these
screws on both
brackets.