Baldwin Boxall BV225 Installation Instructions Manual - page 11
of
16
BV225 Amplifier
Installation Instructions
BV225 Installation Manual issue 3
5
2.2 E
XAMPLE
2: P
ARALLELED
O
UTPUTS
FOR
H
IGHER
P
OWER
Figure 2.2 — Connection Details & Settings for Paralleled Amplifiers
The “Slave” amplifier units obtain their input signal after the pre-
amplifier stage of the “Master” unit. Only one pre-amplifier stage
is required and this ensures the input signal to all power amplifiers
is identical.
The 100V Line Outputs of all units are connected in parallel.
N
OTE
: A six way DIL switch is located on the side panel.
The switch settings must be changed from factory default settings when the
units are used parallelled together.
Master settings: SW1.1 - SW1.6 "ON"
Slave settings: SW1.1 & SW1.2 "ON", SW1.3 - 1.6 "OFF".