Bvrd series microphones installation instructions firmware version: bvrdmic v1.09 manual name: bvrd series microphones issue: 5 ecr: 2785 date of issue: nov 2013.
Bvrd series microphones installation instructions ii bvrd series microphones issue 5 © nov 2013 baldwin boxall communications limited wealden industrial estate farningham road, jarvis brook crowborough east sussex tn6 2jr uk telephone: +44 (0)1892 664422 facsimile: +44 (0)1892 663146 email: mail@bal...
Bvrd series microphones installation instructions bvrd series microphones issue 5 iii amendment record ___________________________________ v proprietary notice ____________________________________ v safety information ___________________________________ vi comments___________________________________...
Bvrd series microphones installation instructions iv bvrd series microphones issue 5 to broadcast bgm (background music) to selected zones - - - - - - - - 14 to cancel bgm (background music) to selected zones - - - - - - - - - 14 emergency (dva) messages in paging mode - - - - - - - - - - - - - - 14...
Bvrd series microphones installation instructions bvrd series microphones issue 5 v a mendment r ecord p roprietary n otice all data and information contained within this manual is of a proprietary nature with the exclusive title to the same held by baldwin boxall communications limited. The possess...
Bvrd series microphones installation instructions vi bvrd series microphones issue 5 s afety i nformation personnel who install, maintain or repair this equipment must read the safety information below before starting work. Voltages in excess of 30 volts rms or 50 volts dc are considered hazardous a...
Bvrd series microphones installation instructions bvrd series microphones issue 5 1 1 introduction the bvrd series microphones have been designed to provide a wide variety of features suitable for any installation. Figure 1.1 — typical bvrd8 microphone the microphones are configured during commissio...
Bvrd series microphones installation instructions 2 bvrd series microphones issue 5 1.1 t he bvrd s eries m icrophones r ange the range of bvrd microphones include the following types: microphones with more than 32 zones are available to order. 1.2 m icrophone o ptions & f eatures all microphones in...
Bvrd series microphones installation instructions bvrd series microphones issue 5 3 1.3 t echnical s pecification audio nominal output level +10dbm max output (limiter operating) +18dbm output impedance 8 ohms frequency response (-3db) 200hz - 12khz power requirement (24v dc) bvrd8 35ma standby (130...
Bvrd series microphones installation instructions 4 bvrd series microphones issue 5.
Bvrd series microphones installation instructions bvrd series microphones issue 5 5 2 installation 2.1 bms8 t ermination b ox all microphones use a single rj45 (cat5 network) connection, which is usually terminated to a local wall mounted bms8 termination box. Figure 2.1 — typical bms8 termination b...
Bvrd series microphones installation instructions 6 bvrd series microphones issue 5 2.2 c able i dentification the colour codes of the rj45 conductors are as follows: 2.2.1 colour code for processor bypass switch the colour code for units with a bypass switch fitted are as shown above, the bypass ac...
Bvrd series microphones installation instructions bvrd series microphones issue 5 7 3 firmware configuration 3.1 i ntroduction it is necessary to configure the bvrd microphone prior to use. This configuration includes setting system specific options such as communication protocols, naming the inputs...
Bvrd series microphones installation instructions 8 bvrd series microphones issue 5 3.2 bvrd usb c onfig s oftware install the “bvrd usb configuration software”. The software includes comprehensive on-line help that explains how to correctly configure the unit to suit the installation. Figure 3.2 — ...
Bvrd series microphones installation instructions bvrd series microphones issue 5 9 table 3.1 — default factory settings 3.4 c learing “l atched ” l ine f aults the bvrd series microphones can be configured to “latch” line faults. If a line fault is detected by the system, the microphone can be set ...
Bvrd series microphones installation instructions 10 bvrd series microphones issue 5 3.5 t emporary “b uzzer m ute ” to temporarily silence the fault buzzer use the following procedure: 1. Disconnect the rj45 network cable. 2. Turn the “emergency mode” keyswitch 45°, and press and hold the dva messa...
Bvrd series microphones installation instructions bvrd series microphones issue 5 11 4 operating instructions 4.1 c ontrols & i ndicators figure 4.1 — bvrd microphone front panel controls & indicators a zone status lcd displays g voice alarm active indicator b zone select buttons h message status lc...
Bvrd series microphones installation instructions 12 bvrd series microphones issue 5 4.2 v iewing the c urrent s tatus of the s ystem 4.2.1 zone status lcd displays the zone status lcd displays (item a in figure 4.1) show the name of the zone, what is currently being broadcast by the zone and also i...
Bvrd series microphones installation instructions bvrd series microphones issue 5 13 4.3 i n “p aging ” m ode (k eyswitch not turned ) 4.3.1 to make an “all call” paging announcement 1. Press the “speak” button (item “l” in figure 4.1) and wait for the “speak now” indicator to illuminate. 2. Speak s...
Bvrd series microphones installation instructions 14 bvrd series microphones issue 5 4.3.3 to broadcast bgm (background music) to selected zones 1. Select the required zones using the “zone select buttons” (item “b” in figure 4.1). The zone status displays will show “selected” for the relevant zones...
Bvrd series microphones installation instructions bvrd series microphones issue 5 15 4.4 i n “e mergency ” m ode (k eyswitch t urned 45°) 4.4.1 to make an “all call” emergency live announcement 1. Press the “speak” button (item “l” in figure 4.1) and wait for the “speak now” indicator to illuminate....
Bvrd series microphones installation instructions 16 bvrd series microphones issue 5 4.4.3 to play a dva message to all zones 1. Press the zone selection button configured for “select all” or press every zone selection button (item b in figure 4.1), or press the relevant function button (item c in f...
Bvrd series microphones installation instructions bvrd series microphones issue 5 17 4.5 f ault r eporting 4.5.1 common / system faults if a fault is reported on the system the common “system fault” indicator will flash and the internal buzzer will sound. To accept the fault and silence the buzzer, ...
Bvrd series microphones installation instructions bvrd series microphones issue 5 19.
Bvrd series microphones installation instructions 20 bvrd series microphones issue 5.