Ballistic Linehaul R247 User Manual - page 3
Ballistic User Guide
4
Ballistic User Guide
5
LINEHAUL R247
GETTiNG STArTEd
Turning the phone on and off
To turn the phone on, hold down the
green (SND)
key for 2 secs until
you see the screen light up. The
red (END)
can also turn the phone on.
To turn the phone off, hold down the
red (END)
key for 2 secs until you
see the
goodbye… screen.
Inserting Internal SIM and battery – prior to installation
Remove the lower back cover (unscrew the 2 screws holding the cover
on) to locate the SIM holder.
Flip open the SIM holder and place the SIM in, network logo facing
up, notched corner facing the bottom right corner as per
diagram 1.
Ensure the holder clips over the SIM cleanly.
Insert the battery – this provides smooth power to the phone whilst
the engine is starting.
Reattach the back and install on the dash.
Note: For dangerous goods vehicles, it is ok to not use the internal
battery.
Inserting External SIM (diagram 2)
With the phone powered off: Hold the phone facing up and locate the
slot on the left side of the phone and insert the SIM as per diagram 2;
ie gold contacts facing down and notched corner in first.
To remove from this slot:
With the phone powered off, press on the
SIM and the SIM will spring out for removal.
MAiN FEATurES
• Dual SIM capability
• Ability to change screen backlight and keypad brightness
independently of each other in both the active and idle modes.
• Multiple alarms – 8 in total
• Multiple size fonts - small, medium and large
• Big Buttons
• Loud,clear audio
Fixed in-vehicle:
• Network barring option to allow/bar incoming and outgoing calls
(Network dependent)
• SMS barring option to allow/bar incoming and outgoing SMS
(Network dependent)
• Fixed in-vehicle installation has an optional accessory privacy
handset
duAL SiM
The installer can put the fleet SIM as the internal SIM prior to mounting
on the dash. The driver can put a personal SIM in the external slot –
Use Menu,6 to swap between SIMs.
Note: Only
one SIM can be in use at any time so it is necessary to
swap SIMs to check for calls or messages on the other SIM.
AuTO idLE
The phone default is to have auto idle ON.
The level of
idle brightness for the keypad and screen can be changed
via Menu,5,4,2,1.
The level of
active brightness for the keypad and screen can be
changed via Menu,5,4,2,2 and Menu,5,4,2,3.
Diagram 1
Diagram 2
Inserting
internal
SIM
Inserting
external
SIM
MAiN FEATurES
GETTiNG STArTEd