Bananza UHD 125 Installation, Operation & Service Manual - Caution

 UHD L

OW

 P

ROFILE

 D

UCT

 F

URNACE

 I

NSTALLATION

 O

PERATION

AND

 S

ERVICE

 M

ANUAL

4 of 47

SECTION 2: INSTALLER RESPONSIBILITY

The installer is responsible for the following:

• To install the heater, as well as the gas and 

electrical supplies, in accordance with applicable 

specifications and codes. Bananza 

recommends the installer contact a Local 

Building Inspector or Fire Marshal for guidance.

• To use the information given in a layout drawing 

and in the manual together with the cited codes 

and regulations to perform the installation.

• To install the heater in accordance with the 

clearances to combustibles.

• To furnish all needed materials not furnished as 

standard equipment.

• To plan location of supports, vents and air 

intakes.

• To provide access for servicing.

• To provide the owner with a copy of this 

Installation, Operation and Service Manual.

• To never use heater as support for a ladder or 

other access equipment and never hang or 

suspend anything from heater.

• To ensure there is adequate air circulation 

around the heater and to supply air for 

combustion, ventilation and distribution in 

accordance with local codes.

• To provide a method that ensures that the air flow 

through the heat exchanger is within the 

acceptable range indicated on the rating plate 

prior to energizing the heater, and that such air 

flow continues at least 90 seconds after the 

heater is de-energized.

• To ensure the heater is placed in an approved 

application.

2.1 Wall Tag

A laminated wall tag is included with the heater as a 

permanent reminder of the safety instructions and 

the importance of the required clearances to 

combustibles. Affix the tag by peeling off the backing 

of the adhesive strips on the rear surface and 

position the tag on a wall near the heater.

A copy of the wall tag (P/N 91039832) is illustrated 

on the back cover.

Know your model number. Model number is found 

on the heater and throughout the Installation, 

Operation and Service Manual. 

2.2 Corrosive Chemicals

Bananza cannot be responsible for ensuring that all 

appropriate safety measures are undertaken prior to 

installation; this is entirely the responsibility of the 

installer. It is essential that the contractor, the sub-

contractor, or the owner identifies the presence of 

combustible materials, corrosive chemicals or 

halogenated hydrocarbons* anywhere in the 

premises.

* Halogenated Hydrocarbons are a family of chemical 

compounds characterized by the presence of halogen 

elements (fluorine, chlorine, bromine, etc.). These com-

pounds are frequently used in refrigerants, cleaning 

agents, solvents, etc. If these compounds enter the air 

supply of the burner, the life span of the heater compo-

nents will be greatly reduced. An outside air supply must 

be provided to the burners whenever the presence of 

these compounds is suspected. Warranty will be invalid 

if the heater is exposed to halogenated hydrocarbons.

2.3 National Standards and Applicable Codes

All appliances must be installed in accordance with 

the latest revision of the applicable standards and 

national codes. This refers also to the electric, gas 

and venting installation. Note: Additional standards 

for installations in public garages, aircraft hangars, 

etc. may be applicable.

CAUTION

Product Damage Hazard

Do not use heater in area containing 

corrosive chemicals.

Refer to appropriate Material Safety Data 

Sheets (MSDS).

Failure to follow these instructions can result 

in product damage.