Bananza UHD 150 series Operation Manual - page 40

UHD S

TANDARD 

D

UCT 

F

URNACE 

I

NSTALLATION 

O

PERATION AND 

S

ERVICE 

M

ANUAL

32 of 55

11.3 Pressure Switch

The pressure switch is factory pre-set for each 

model and is not adjustable.

11.4 Turning Off the Heater

Set the thermostat to the 

"

OFF

"

 position or lowest 

setting and the main burner will stop.

11.5 External Controls

External controls may include time switch, interlock 

switch, room thermostat and frost thermostat. 

Operate each control to ensure that they function 

correctly. Set the switches (if fitted) and 

thermostat(s) to the users’ requirements. 

11.6 Complete Start-Up

Ensure that all covers are fitted correctly and all test 

points are properly sealed.

11.7 Instruction to the User

Explain the controls of the heater to the user 

including how to turn it on and off, using the controls 

fitted on site. 

Give this manual to the user.

Ensure that the user is shown and understands the 

importance of maintaining clearances to 

combustibles on Page 7, Figure 4, installer 

responsibility on Page 5, Section 2 and user 

instructions on Page 33, Section 12 and all 

warnings defined in this manual.