Band Shoppe LONG RANGER IV Operating Instructions And Troubleshooting Manual - page 3
F I R S T P L A C E S T A R T S H E R E ™
PH 800.457.3501 • BANDSHOPPE.COM
UPDATED 10.07.2004
LONG RANGER IV: OPERATING INSTRUCTIONS & TROUBLESHOOTING GUIDE
3
CONTROLS AND FUNCTIONS: CONTROL PANEL
WIRELESS MICROPHONE VOLUME
Turns unit power on and off and also functions as the volume control for the internal wireless receiver.
POWER
A red LED that lights when unit power is on.
RF
A green LED that lights when the companion transmitter is turned on and there is suffi cient signal for good system operation. Internal circuits
monitor both signal level and interference levels and decide if the transmitted signal is strong and “clean” enough for satisfactory operation.
If not, the green RF LED will go out and the receiver will mute the audio (“squelch”), turning off the sound output. This action is automatic and
requires no user adjustments.
MOD LEVEL
The red and green MOD LEVEL LEDs continuously indicate the modulation level (audio level) of the received signal from the transmitter and are used
when making intial adjustments to the transmitter.
MIC
This connector is a standard ¼” phone jack and is used for plugging in the cord from a low impedance dynamic microphone.
LINE
This mini jack is used for connecting high level, high impedance outputs from tape decks or other amplifi ers. It also may be used for connecting the
“earphone” output from portable cassette players.
AUXILIARY INPUT VOLUME
Adjusts the volume of the MIC and LINE inputs.
AUX IN/OUT
An RCA phone jack that functions both as a line level input and line level output. This “omnibus” jack is primarily used for interconnecting several
Long Rangers together for simultaneous operation. This jack can also be used with a tape deck to either record from or play back into the Long
Ranger. When used with a tape deck or other audio source, the sound output level must be controlled by the volume control on the tape deck since
there is no volume control on the Long Ranger for the AUX IN/OUT jack. When an external device is connected to this jack, the loudness of the Long
Ranger will usually be reduced.
DCR15/2AU CHARGER
A special jack used for connecting the charger when charging the battery pack. The green LED located under the jack lights when the batteries are
charging. This LED automatically goes out when the batteries are almost fully charged.
12V DC OUTPUT
A special jack used to supply power to the Add-On receiver when that option is installed.