Bang & Olufsen BeoCom 6000 Manual - page 6
6
Get started with BeoCom 6000
First-time registration of the handset to a base
In order for the base and the handset to communicate, the handset
must be registered to the base. Up to 6 handsets can be registered
to one base, and each handset can be registered to up to 4 bases.
To register a handset, follow the procedure corresponding to the
type of base you have:
If you have a BeoCom 6000 base…
Press and hold the button on the base for two
seconds. The indicator light flashes red, and the
base is ready for registration for five minutes
Press to switch on the handset
Press to be able to register the handset.
REGISTER BASE? is shown in the display
Press to continue. The handset searches for an
open base
When a base is located, the PARK number
identifying the base is shown. Check the number
against the number on the bottom of the base
If the numbers do not match, turn the wheel to
view the available bases. If the desired base is
not shown, open the base for registration once
more and repeat the procedure. Otherwise…
Press to register the handset to the base
If the base prompts you for a PIN code, enter the
PIN code and press OK. The display tells you
when registration is complete
REGISTER BASE?
OK
BASE 01/01
36-000077123456
OK
0 – 9
OK
The BeoCom 6000 base. The PARK
number identifying the base is
visible on the bottom. Check this
number against the number in the
handset display.
Base indicator light
Button