Bang & Olufsen BeoLab 2 6861 Repair Manual - page 6
CORNER
WALL
FREE
~ 50 cm
20"
~ 150 cm
60"
BRIEF OPERATION GUIDE
Setting the POSITION switch
Use the POSITION switch is to ensure that the bass response suits the placement of
BeoLab 2, and thus the surroundings.
Which switch setting to choose depends on the distance from BeoLab 2 to the
walls and corners of the room.
The POSITION switch has three settings:
CORNER: Use this setting if BeoLab 2 is placed in a corner – shown by the dark
grey areas in the illustration.
WALL: Use this setting if BeoLab 2 is placed closer than approx. 50 cm (20”) to a
wall, and no closer to a corner than approx. 150 cm (60”) – shown by the medium
grey areas along the walls in the illustration.
FREE: Use this setting if BeoLab 2 is placed more than approx. 50 cm (20”) from the
wall – shown by the light grey area in the illustration.
Never place BeoLab 2 behind your listening position. We recommend that you avoid placing any of
your loudspeakers in the area inside the thin dotted line.
Setup examples
Dolby Digital system
- Connect one end of the cable to the socket marked IN on BeoLab 2, and the other
end to the socket marked SUBWOOFER on your Bang & Olufsen system.
- Connect your front set of speakers to the sockets marked FRONT on your Bang &
Olufsen system.
- Connect your rear set of speakers to the sockets marked REAR on your Bang &
Olufsen system.
R
L
R
L
IN
SUBWOOFER
REAR
REAR
FRONT
FRONT
'Dolby Digital system'
2.1 Brief operation guide, English