Bang & Olufsen BeoLab 2 6861 Repair Manual - page 8
USA
Connect loudspeakers with BeoSystem 1
Using the cables enclosed with the loud-speakers, connect the speakers to the
BeoSystem 1 rear connection panel. The front, center and rear sets of loudspeakers
must be from the Bang & Olufsen range of Power Link speakers. However, you are
not restricted to the speaker models shown in the illustration. For more information
concerning sockets on BeoSystem 1, please refer to Connection panels on
BeoSystem 1 in the User Guide.
- Connect the two front loudspeakers to the sockets marked FRONT.
- Connect the two rear loudspeakers to the sockets marked REAR.
- Connect both centre speakers to the socket marked CENTRE in the following
manner: Connect one loudspeaker to its counterpart, and connect the second
loudspeaker to the CENTRE socket on BeoSystem 1. You can also use this looping
method when connecting your front or rear loudspeakers. Refer to the guide
enclosed with your speakers for more information about ‘looping’ your
loudspeakers.
- You can connect a subwoofer to the socket marked SUBWOOFER.
FRONT
SUBWOOFER
REAR
CENTRE
L
R
L
R
Regardless of which method you use when connecting your speakers, remember to set the
L • R • LINE switch on the speakers to L and R (left and right channel), respectively.
2.3 Brief operation guide, English