Guide beolab 7-1 beolab 7-2.
Cautions! – make sure that the loudspeaker is placed and connected in accordance with the instructions in this guide. – do not attempt to open the loud- speaker. Leave such operations to qualified service personnel! – the loudspeaker is designed for indoor use in dry, domestic environments only, and ...
Daily use when you have finished setting up the loudspeaker as described on the following pages, connect the entire system to the mains. Loudspeaker protection the loudspeaker is equipped with a thermal protection system which prevents damage from overheating. If an error occurs – or the speaker unit...
Set up the loudspeaker we recommend that you follow this procedure: – disconnect your bang & olufsen system from the mains. – mount the loudspeaker to the bang & olufsen stand or wall bracket as explained on the next page. – connect the loudspeaker as explained in ‘cable connections’ (pp. 6–7). – se...
Here is shown how to fasten the loudspeaker with a ‘ type 1 bracket’ to a bang & olufsen ‘single-column’ stand (or wall bracket). Use the same procedure if you wish to fasten the loudspeaker to a bang & olufsen ‘double-column’ stand – with a ‘ type 2 bracket’ . A remove the small cover (if any) on t...
Cable connections the loudspeaker is primarily intended to be used in a setup with beovision 7*. It may, how- ever, be used with other bang & olufsen systems as well – for example in a beovision 4 setup. If used in a setup not including beovision 7, you will require a mains cord and a power link cab...
Connection to other bang & olufsen systems … use a power link cable of the correct type to connect the loud- speaker to a power link socket on the bang & olufsen system. For further information, refer to the guide enclosed with the bang & olufsen system. Power link cable: do not use a cable of the o...
Adapt the loudspeaker to your room when a loudspeaker is placed in a corner or close to a wall, the bass level is boosted compared to the bass level from a loudspeaker placed in a more free-standing position. To remove this excessive bass boost, use the position switch to ensure that the bass level ...
The position switch is located on the loudspeaker socket panel. How to measure … the distance is measured as shown here – the loudspeaker seen from above. F w 9.
To get access to the approval labels, remove the loudspeaker front grill: push the front grill towards the left (~ 10 mm). The front grill can now be removed. Note: when attaching the front grill again, make sure that all five ‘attach-points’ engage with the corresponding brackets on the loud- speak...
For the canadian market only! This class b digital apparatus meets all requirements of the canadian interference-causing equipment regulations. This product fulfils the conditions stated in the eeu directives 89/336 and 73/23. Technical specifications, features and the use thereof are subject to cha...
Www.Bang-olufsen.Com.
