Bang & Olufsen BeoLink Wireless 1 Manual - page 9
Cable connections
In the main room: Connect the
transmitter to the Master Link
socket on the main system. Then
connect both the main system and
transmitter to the mains supply.
In the link room: Connect the
loud speakers to the Power Link
sockets on the receiver. Connect
the ‘IR-eye’ to the socket marked
IR (for information about the ‘IR-
eye’ and its cable, see p. 11). Then
connect both the loud speakers and
the receiver to the mains supply.
Check the indicator light in the
receiver to ensure that connection
is still intact. If the connection is
lost, the units must be moved. The
receiver switches to standby after
approximately 20 seconds.
IMPORTANT: Use fully mounted
Power Link cables only – not the
very thin type! If a wrong type of
Power Link cable is used, the link
room speakers will not play. If in
doubt, ask your Bang & Olufsen
retailer.
IR
R
T
PL
ML
PL
MASTER LINK
BeoLink
Wireless 1
BeoLink
Wireless 1
T
R
9
Main room
Link room
Master Link
connection
Receiver/Transmitter
switch
Connection button
Light indicator