B e o s o u n d o u v e r t u r e.
2.
3 b e o s o u n d o u v e r t u r e this setting-up guide explains how to assemble your beosound ouverture and make it ready for use. It describes how to set up the system with a pair of matching beolab 2500 speakers or, as an alternative, with a pair of active bang & olufsen loudspeakers. The beoso...
4 b e f o r e y o u s t a r t … make sure that the following parts are available before you start setting up the beosound ouverture: • one set of glass doors (left and right). • one cable cover, for concealing and holding the cables on the rear of the beosound ouverture. • one lead for connection to...
5 p l a c e m e n t your beosound ouverture is designed for a variety of place- ments. Its compactness facili- tates placement next to your favourite listening position, which is also optimal for close- up operation of the system. It can be placed on a special stand, on a shelf or a table – or hangi...
6 c o n n e c t i o n s if no permanent fm aerial connection is available, an in- door aerial may be hooked on- to the clamp on the back of the beosound ouverture. When using an am loop aerial, tune in to the radio station you want and then turn the aerial horizontally until optimum signal is receiv...
7 beolink connection the socket marked master link should be used when you interconnect your beosound ouverture and a compatible bang & olufsen video system. Using a beolink cable, connect one plug to the socket on the beosound ouverture and the other end to the corresponding socket on the beovision...
8 > connections beolab 2500 loudspeakers this page shows how to connect a pair of matching beolab 2500 speakers to your beosound ouverture: • arrange all the connectors in the cable cover as shown. • fasten the cover to the grill on the beosound ouverture rear panel (see page 7). • connect all the c...
9 a s s e m b l i n g glass doors the label on the back of each door indicates which end must point upwards, and which side must point towards the centre of the beosound ouverture. Fasten the glass doors, one at a time, to the front of the beo- sound ouverture by pressing their fastening points into...
10 r e a d y f o r u s e … to complete the setting-up procedure, make your presettings of sound levels, favourite radio stations, etc. As described in the beosound ouverture user’s guide. When you have finished setting up your beosound ouverture (and any other equipment), connect it to the mains usi...
11 in a fully integrated bang & olufsen av system, your beo- sound ouverture acts as a mere audio source. The sound is re- produced through the speakers in the beovision tv – or, as shown here, through at set of active speakers connected to the tv. In a one-room av integrated setup, a pair of active...
12 m a i n t e n a n c e use a soft, dry cloth to wipe dust off the beosound ouver- ture. Do not use alcohol or other solvents to clean any part of the beosound ouverture! Before you start cleaning the beosound ouverture, we re- commend that you disconnect it from the mains to prevent the glass door...
13 environmental information this bang & olufsen product was delivered in a packing made to protect and transport the product safely from the factory to your home. In the design of our packing we use the most conserving and recyclable materials known to- day, and we constantly work to reduce any neg...
3505632 0993 printed in denmark by bogtrykkergården a-s, struer.
