Banner American ValueLam 4500 Operating Instructions Manual - page 5
5
Do not leave the laminator power on for extended periods while not in use.
Unplug the machine at the end of the day as a precaution against a possible
fire
hazard.
Do not operate the laminator with a damaged power supply cord or plug.
Replace fuses only with same type rated 20, 250V and 1A, 250V fuses.
Contact your dealer for replacement fuses.
There are two (2) EMERGENCY STOP buttons on the laminator, one on each
side. Depressing one of these buttons will stop the rollers.
III. Specifications...
Operating Speed:
Adjustable to 5 fpm (2.54cm/sec.)
Power Requirements
Voltage: 108-125
VAC,
50/60
hz
Warm Up Time:
25-30 minutes
Power
Fuse:
20
A
Motor
fuse:
1A
Maximum Laminating Dimensions
Thickness:
¼”
(6.35mm)
Width
Capacity:
45”
(1143mm)
Net Weight:
183 lbs
Shipping
Weight: 383
lbs
IV. Set-up...
Inspection:
Upon receipt of your ValueLam 4500, inspect the crate, the machine and all other contents of
the crate for shipping damage. Damage should be brought to the immediate attention of the
delivering carrier.
Power Requirements:
The ValueLam 4500 is designed to operate on a 110 Volt, 20 Ampere circuit. It will plug into a
standard 110 volt wall receptacle. You must ensure that the circuit is protected by a 20 Amp
circuit breaker.
Appropriate Location:
The laminator must be placed on a sturdy table or stand in a clean, well lit area with ample
space on all four sides of the laminator.