Barazza 1FOFM7X-00 series Installation And Use Manual - page 19
19
Ajuste del volumen de la señal acústica
Desplace la secuencia de las funciones tocando la tecla
SELECT hasta que el display muestre la selección
de la SEÑAL ACÚSTICA “L1, L2 o L3”. Defina el valor
utilizando las teclas “+” o “-“.
Volumen de la SEÑAL ACÚSTICA
L1
= bajo
L2
= medio
L3
= alto
Ajuste del temporizador (fig.16)
A) Ajuste del temporizador
Desplace la secuencia de las funciones tocando la tecla
SELECT hasta encontrar el símbolo parpadeando.
Ajuste el TEMPORIZADOR utilizando las teclas “+” o “-“
hasta un máximo de 99:00 min:seg.
B) Activación del ajuste
5 segundos después de definir el valor, comienza la
cuenta atrás a intervalos de un segundo, hasta llegar
a 00:00 min:seg. El display muestra el símbolo del
TEMPORIZADOR sin parpadear. Durante la confi-
guración de otras funciones, se oculta temporalmente.
C) Modificación /desactivación de ajustes
El tiempo restante puede modificarse en cualquier
momento utilizando las teclas “+” o “-“. La cuenta atrás
puede desactivarse poniendo el valor a 00:00 min:seg.
El tiempo programado se agota cuando el valor llega
a 00:00 min:seg. El símbolo del TEMPORIZADOR
parpadea y se emite una SEÑAL ACÚSTICA.
Después de tocar cualquier tecla, la función TEM-
PORIZADOR concluye automáticamente. El display
muestra la HORA DEL DÍA actual; la SEÑAL ACÚSTICA
y el símbolo del TEMPORIZADOR se desactivan.
Setting acoustic signal volume
Step through the sequences of function with Touchpad
SELECT until the display shows the chosen ACOUSTIC
SIGNAL L1, L2 or L3. Select the value with Touchpad
“+” or “-“.
ACOUSTICAL SIGNAL volume
L1= low
L2= medium
L3= loud
Setting the timer (fig.16)
A) Set Timer
Step through the sequences of function with Touchpad
SELECT until the symbol flashes. Set the TIMER by “+”
or “-“ up to a maximum of 99:00 min:sec.
B) Timer runs down
5 seconds after setting the value, count down starts in
steps of seconds to 00:00 min:sec.
The display shows the symbol TIMER . The remaining
time is displayed continuously. While setting other func-
tions the TIMER counts down covertly.
C) Modifying / Deleting Timer
The remaining time can be changed anytime by using
Touchpad “+” or “-“. The countdown is deleted by setting
to 00:00 min:sec.
The time has expired once the value has reached 00:00
min:sec. The symbol TIMER flashes, an ACOUSTIC
SIGNAL occurs.
After touching any Touchpad, the TIMER mode termina-
tes automatically. The display shows the current TIME
of DAY, the ACOUSTIC SIGNAL and the TIMER symbol
are switched off.
min:sec
Auto
h:min
Man
min:sec
Auto
h:min
Man
15